howto:bootes:bootes_ir
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Previous revisionLast revision | |||
— | howto:bootes:bootes_ir [2008/11/12 23:45] – pkubanek | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Dome opening and closing ====== | ||
+ | |||
+ | You cannot open dome manually using buttons in copula if // | ||
+ | |||
+ | If you left dome in remote mode, and you try to open it, it will close as soon as you release opening button. That is a new security feature, which makes sure that dome is closed if it should be closed. Removing it will affect our other setups, and as there is a solution for manual control, I am not inflicting towards removing it. You can open dome from // | ||
+ | |||
+ | ====== Telescope referencing ====== | ||
+ | |||
+ | Aug 27nd: Telescope is know to not reference if on clokwise end. The solution is: | ||
+ | |||
+ | < | ||
+ | telnet tel 65432 | ||
+ | 1 set az.power=0 | ||
+ | </ | ||
+ | |||
+ | then gently turn in AZ axis counter-clokwise (eg. starting with camera facing valley, move towards Veleta and then OSN building). The end switch is located bellow telescope, see this image: | ||
+ | |||
+ | {{: | ||
+ | |||
+ | Gently move telescope in AZ axis till you hit the end. | ||
+ | |||
+ | Then | ||
+ | |||
+ | < | ||
+ | telnet tel 65432 | ||
+ | 1 set az.power=1 | ||
+ | </ | ||
+ | |||
+ | And it should reference in AZ axis. | ||
+ | |||
+ | ====== Setting dome parking position ====== | ||
+ | |||
+ | Dome park position can be set only locally on dome control box. The box has eight small buttons and five line of LCD display. First, switch box to **remote** mode by turning key clokwise. Then press simultaneusly left and right top buttons. System will enter **technical** mode, where you can change various parameters. Using right and left top buttons, move to screen 3 (axis 0). Using bottom buttons, move cursor to **park position** which is a few lines bellow initial display. Using middle two buttons, change park value. Move a line down to confirm value and see that system accept it. | ||
+ | |||
+ | To save park position, so it will be remembered after power cycling of the dome control box, go to screen 18 and set **Save params** to 1. Move line down/up, you will get **Written 83.." message on screen, which will disappear after a while. | ||
howto/bootes/bootes_ir.txt · Last modified: 2008/11/12 00:00 (external edit)