howto:change_variables_from_a_terminal_session
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
howto:change_variables_from_a_terminal_session [2012/04/17 19:20] – [Using rts2-xmlrpcclient] jtello | howto:change_variables_from_a_terminal_session [Unknown date] (current) – external edit (Unknown date) 127.0.0.1 | ||
---|---|---|---|
Line 14: | Line 14: | ||
Then you must simply run " | Then you must simply run " | ||
- | For example to run a specific target: | + | For example to set a specific target |
rts2-xmlrpcclient -s EXEC.next 3 | rts2-xmlrpcclient -s EXEC.next 3 | ||
| | ||
Line 22: | Line 22: | ||
echo " | echo " | ||
See the man page of at for other ways to specify time. Remember this is by default in local telescope time. | See the man page of at for other ways to specify time. Remember this is by default in local telescope time. | ||
+ | |||
+ | Another important feature is to send commands, which is not the same as setting variables. For example if you want the executor to stop the current observation and observe a specific target immediately: | ||
+ | rts2-xmlrpcclient -c EXEC.now 3 | ||
+ | |||
+ | This is also good for parking or moving the telescope or asking the dome to " |
howto/change_variables_from_a_terminal_session.1334683212.txt.gz · Last modified: 2012/04/17 00:00 (external edit)