howto:disable_selector
Differences
This shows you the differences between two versions of the page.
Previous revisionNext revision | |||
— | howto:disable_selector [2009/06/26 16:11] – wildi | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== Disable selector ====== | ||
+ | Selector is component responsible for selecting next targets. You can check if it is running by executing ps -A|grep selector. If the reply is not empty, e.g. you will receive: | ||
+ | |||
+ | < | ||
+ | user@host: | ||
+ | 19126 pts/7 00:00:00 rts2-selector | ||
+ | user@host: | ||
+ | </ | ||
+ | |||
+ | then selector is running. If you would like to work directly with the executor, you shall proceed with following instructions to disable it. | ||
+ | |||
+ | - run rts2-mon | ||
+ | - press key down/key up until you reach SEL component. //Please note that SEL is usual name. If you are unsure about selector name, please consult / | ||
+ | - press tab key (tabulator, usually located on upper left corner of your keyboard) to switch black bar to left | ||
+ | - press key dow to reach sel_enable entry | ||
+ | - press enter key to bring up a popup menu | ||
+ | - press key down to change true to false | ||
+ | - press enter | ||
+ | |||
+ | You can see screencast of this action in this [[http:// | ||
+ | |||
+ | {{ youtube> |
howto/disable_selector.txt · Last modified: 2009/06/26 00:00 (external edit)