howto:bootes:bootes_ir
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
howto:bootes:bootes_ir [2008/08/27 13:14] – pkubanek | howto:bootes:bootes_ir [2008/11/12 23:34] – pkubanek | ||
---|---|---|---|
Line 22: | Line 22: | ||
And it should reference in AZ axis. | And it should reference in AZ axis. | ||
+ | |||
+ | ====== Setting dome parking position ====== | ||
+ | |||
+ | Dome park position can be set only locally on dome control box. The box has eight small buttons and five line of LCD display. First, switch box to **remote** mode by turning key clokwise. Then press simultaneusly left and right top buttons. System will enter **technical** mode, where you can change various parameters. Using right and left top buttons, move to screen 3 (axis 0). Using bottom buttons, move cursor to **park position** which is a few lines bellow initial display. Using middle two buttons, change park value. Move a line down to confirm value and see that system accept it. | ||
+ | |||
+ | To save park position, so it will be remembered after power cycling of the dome control box, go to screen 18 and set **Save params** to 1. Move line down/up, you will get **Written 83.." message on screen, which will disapear after while. | ||
howto/bootes/bootes_ir.txt · Last modified: 2008/11/12 00:00 (external edit)