Differences

This shows you the differences between two versions of the page.

--- howto:bootes:bootes_ir [2008/08/27 19:56] – 88.16.139.239
+++ howto:bootes:bootes_ir [2008/11/12 23:34] – pkubanek
@@ Line 25: / Line 25: @@
 ====== Setting dome parking position ======
-Dome park position can be set only locally on dome control box. The box has eight small buttons and five line of LCD display. First, switch box to **remote** mode by turning key clokwise. Then press simultaneusly left and right top buttons. System will enter **technical** mode, where you can change various parameters. Using right and left top buttons, move to screen 4. Using bottom buttons, move cursor to park position which is a few lines bellow initial display. Using middle two buttons, change park value.
+Dome park position can be set only locally on dome control box. The box has eight small buttons and five line of LCD display. First, switch box to **remote** mode by turning key clokwise. Then press simultaneusly left and right top buttons. System will enter **technical** mode, where you can change various parameters. Using right and left top buttons, move to screen 3 (axis 0). Using bottom buttons, move cursor to **park position** which is a few lines bellow initial display. Using middle two buttons, change park value. Move a line down to confirm value and see that system accept it.
-To save park position, so it will be remembered after power cycling of the dome control box, go to screen 18 and set **Save params** to 1.
+To save park position, so it will be remembered after power cycling of the dome control box, go to screen 18 and set **Save params** to 1. Move line down/up, you will get **Written 83.." message on screen, which will disapear after while.