Differences

This shows you the differences between two versions of the page.

--- howto:intergation_of_a_davis_meteo_station [2009/08/30 15:26] – created wildi
+++ howto:intergation_of_a_davis_meteo_station [Unknown date] (current) – external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
 =====Prerequisites =====
-  * Get {{http://lascaux.asu.cas.cz/~petr/meteo-0.9.17.tar.gz| the special version}} of {{http://meteo.othello.ch/ meteo}} and compile, install and configure it as usual.
+  * Get {{http://rts2.org/meteo-0.9.17.tar.gz| the special version}} of {{http://meteo.othello.ch/ meteo}} and compile, install and configure it as usual.
-  * Start ''meteopoll'' with <code bash>         /sbin/startproc $METEO_POLL_BIN -l syslog:local0 -s ${station} \
+  * Start ''meteopoll'' with<code bash>         /sbin/startproc $METEO_POLL_BIN -l syslog:local0 -s ${station} \
                                    -f $METEO_CONFIG \
                                    -U YOUR_DESTINATION_HOST -P 5002\
@@ Line 7: / Line 7: @@
  </code>where YOUR_DESTINATION_HOST ist the host, where ''rts2-sensor-davis'' is running.
 ===== Configuration ======
+  * In the file usually found in ''/etc/rts2/devices'' add the line <code bash>
+ sensor  davis   MET    --max-peek-windspeed 5.0  --max-avg-windspeed 3.0 --udp-port 5002</code> Configure the device name and the values appropriately.
+===== Screen shot ======
+{{ howto:rts2-mon-weather.png?300|The Davis meteo station as seen with rts2-mon.}}